Genuine fully working Credit Card / ATM Machine

Engineered for use as a prop, the unit provides a high resolution full colour graphics display which can show any form of PC or MAC generated graphics or video input for use with VTR or live video. Various standard screens are available, these can be easily changed to suit your needs. For more complex requirements, graphics may be originated with PhotoShop, Flash or Director etc. As the display is of the TFT variety there is never a problem with 'rollbar' or ' shutter flicker'. The fully interactive keyboard, card insert / eject, and money (sandwich even !) eject system are all remotely controlled. Supplied built onto a fully adjustable trolley with vertical and horizontal jacking system. All you have to do is to supply a cutout for the unit to fit through !

See notes below for dimensions and other information..

CC011.jpg (84096 bytes)

Typical graphics screens:

Insert_card2.bmp (746552 bytes) ACC_CLOSED.bmp (746552 bytes)

pin.bmp (746552 bytes)

barc.bmp (746552 bytes)

remove.bmp (770744 bytes)
joke1.bmp (770744 bytes)
See more typical screens HERE
    

cc_data._int2.gif (28794 bytes)

Installation & General Notes
The ATM is constructed with the top (prop section) able to slide forward from the base unit, this allows the prop section to overhang, as shown above, any floor mounted obstacles or walls etc. The minimum floor space required behind the flat or wall is 29" (737mm) square. The prop is also mounted on jack legs to allow vertical height adjustment.  Ensure front face of prop / flat is at right angle to floor and floor area behind prop is as level / flat as possible. Maximum height from bottom edge may be increased by sturdy staging at prop rear – note unit weighs in excess of 200 lbs. / 90 kgs. Unit operates from 230 Volt AC 50Hz mains supply. This supply should be as clean as possible, unit may take at least 4 minutes to reboot in the event of an unscheduled power break. If used on location where continuous normal mains power not available, inform our booking department who will endeavor to provide a UPS to prevent downtime. The colour display used on this item is of the TFT liquid crystal variety which does not create flicker, therefore anti roll bar camera sync is not required. It should be noted that although the display will give excellent definition, rich colours and good light output, it does NOT perform well in and MUST NOT be exposed for extended periods to direct sunlight. For use of the money/object eject function only, operator will require access to rear of unit. Operator can be located up to 100 ft from machine. If operators view is likely to be obscured, please allow for provision of video feed and monitor for cueing use. We can supply these items if required. If you intend to supply your own graphics, these should be originated to run under the Windows operating system. Call Dave Fisher for further information on graphic formats etc.

Logo's & Brand Names
Logo's on the RHS of the unit are easily changed. All logo/brand name use is the required responsibility of the hirer, clearance of existing registered logo's and brand names must always be obtained prior to use. Maximum logo area is : 150 mm wide x 85 mm high.

Please call if you require any further information.


 HOME              GALLERY

(C) Display Electronics 1999

Hit Counter